Mold size: height: 5.9 in width up: 2.7 in width down: 2.1 in - Weight of the finished candle from the mold is6,9 oz
We propose the engineering plastic molds for candles. They are suitable for filling in wax, paraffin and other base. The material is resistant to high and low temperature (to 120°), that's why the molds are not crackled and not broken down in service. Plastic can contact with the paraffin additives and acid conditions without any hurting. Due to plastics durability the candle molds can be used an unlimited number of times.
The molds are divided into a body and a lid to take a candle out comfortably. We recommend to grease with silicone or oil the mold before filling in for easy taking out. There is a hole in the center of the lid to pull a wick. Use boiling water for cleaning the mold after taking the candle out.
The lower temperature is, the more mat candle surface is. The higher temperature of the filling is, the smoother surface is. But it is necessary to remember that the higher temperature of paraffin filling is, the more difficult it will be to take a candle out the mold. If the temperature is too low, the candle will be too porous. It is impossible to get ideal smooth candle out of these molds. The paraffin temperature for filling in the mold depends on a paraffin grade and its melting temperature. If it is difficult to take the candle out the mold, so put the candle in the mold into a freezer for 20-30 minutes, then take the candle out. It is also possible to heat the mold with a candle by a hair dryer and take the candle out. Before filling in make sure that the hole for a wick is closed for the avoidance of candle mass loss.
Attention: we recommend to fill the molds at the paraffin temperature of 65-75°.
